National Flooring Equipment ROGUE, Руководство по эксплуатации и обслуживанию

Страница: 25 / 84

407170_ROGUE_RevA
MACHINE OPERATION
25 25
STARTING THE MACHINE
STOPPING THE MACHINE
1. Install desired tooling.
2. Make sure the wheels are engaged.
3. Make sure the orbital motor speed is set “below 1”.
4. Plug machine into power source. Verify the power indi-
cator illuminates.
5. Verify the E-stop and lanyard kill switch are not engaged.
6. Tether lanyard kill switch to wrist.
7. Push the “ON” button to turn on the machine. The sys-
tem indicator will turn amber during startup mode (ap-
proximately 10 seconds), then pulsate green indicating
machine is ready to operate.
8. Adjust the maximum drive speed.
9. Adjust orbital motor speed to the desired oscillation rate.
NOTE:
● NFE recommends adjusting the orbital motor speed
only as high as necessary to perform the job. Lower
speeds reduce hand-arm vibration and noise levels.
10. Adjust blade angle to the angle at which the material
comes up the easiest.
11. Set left/right-hand preference switch for desired function-
ality of the control handles.
12. Use the control handles to control the travel direction,
speed and turning of the machine.
1. Turn the orbital motor speed control fully counterclock-
wise to the “below 1” position.
2. Push the “OFF” button.
To avoid personal injury:
●
Avoid excessive pushing, pulling and twisting of
control handles, as machine could be damaged.
CAUTION
PREPARING FOR OPERATION
Complete the following before starting the machine:
1. Inspect wheels, tooling holder, blade holder, handle har-
ness and power cord for damage. Check for loose or
missing fasteners.
2. Clean built-up glue and debris from wheels, front weight
and blade holder.
AFTER OPERATION
1. Disconnect machine from power.
2. Clean built-up glue and debris from wheels, front weight
and blade holder.
3. IMPORTANT:
● Relubricate the wheel bearings after daily use by
disengaging the wheels, then pushing the machine
ahead in freewheel mode allowing the wheels to ro-
tate at least three turns.
4. Engage the wheels so the machine is in drive mode.
5. Remove tooling.
6. Store machine in a dry, secure place.