National Flooring Equipment ROGUE, Руководство по эксплуатации и обслуживанию

Страница: 14 / 84

407170_ROGUE_RevA
SAFETY
14 14
8. Make sure the work area is clear and safe. Be sure to
work on a firm, level surface with adequate lighting.
Work in a well-ventilated area if indoors. Make sure the
area is free from any potentially dangerous conditions
such as obstacles, slippery surfaces, etc.
9. Prohibit unauthorized persons from entering work area.
10. Make sure the machine is secured before beginning
maintenance work.
● Chock the wheels to prevent the machine from roll-
ing.
11. Be sure the machine is clean and free of debris before
performing any maintenance work.
12. Motors run at high temperatures under normal condi-
tions. Clean debris from motors more frequently when
working in severe conditions.
13. Never use a pressure washer or hose to clean the ma-
chine. Water can seep into the electrical components
causing an electrical shock hazard or malfunction of
controls.
14. Use caution when tilting back the machine to change the
blade holder:
● Before tilting back, position slide weights rearward to
make tilting easier.
● Always block the front of the machine to prevent the
machine from falling forward unexpectedly.
15. The machine has components that are at high tempera-
tures under normal operating conditions. The primary
source of high temperatures are the motors. The electri-
cal system, if damaged or incorrectly maintained, can be
a source of arcing or sparks. The following guidelines will
help keep the machine running efficiently and keep the
risk of fire to a minimum.
● Clean accumulated flammable debris from hot com -
ponents. Clean more frequently when working in se-
vere conditions.
● Remove rags, tools, supplies, etc. from the machine
after maintenance is completed.
● Check electrical wiring and connectors frequently for
damage. Repair any wires that are loose or frayed
before operating the machine. Clean and tighten all
electrical connections as necessary.
MAINTENANCE
1. Dress properly and wear adequate safety equipment. All
personnel in the work area must wear eye protection,
ear protection, safety shoes, safety gloves, hard hat,
high visibility safety vest and dust mask. Do not wear
loose clothing as it could get caught in moving parts and
cause injury.
2. Maintenance should only be performed by qualified per -
sonnel.
3. Always turn off machine, disconnect from power and dis -
charge stored energy before performing maintenance.
Variable frequency drives (VFDs) hold stored energy
and pose a serious electrical shock hazard. Always per -
form the following procedure before beginning any work
on machine:
A.
Turn off machine.
B. Leave power cord plugged in 5 minutes.
C. Disconnect power cord.
D. Wait an additional 5 minutes before performing any
service on the machine.
4. Allow the machine to cool down sufficiently before per -
forming maintenance.
● Blade and motor may be very hot immediately after
the machine has been running. Allow these parts to
cool sufficiently before touching.
5. Always stay clear of moving or rotating parts. Clothing,
hands or other body parts can become caught in moving
parts of the machine and cause personal injury.
6. Always attach a “DO NOT OPERATE” tag whenever
performing any kind of maintenance or repair.
7. Make sure you have the proper tools on hand. Do not
use defective or damaged tools. Always use tools that
are appropriate for the task to be done.