Mylex Disk Array controller Software Kit 2.01, Руководство по установке и инструкция пользователя

Страница: 158 / 172

Enabling and Running RAID Fault Management (RAIDBLD)
C-4 Disk Array Controller Software Kit User’s Manual
Table C-1. Command Line Parameters and Their Functions
Param Value(s) / Default / Example Description
-s Values = 1,2,3,4, etc.
Default = -s 7
Example = raidbld -s 10
Define Scan Interval: Sets the
number of seconds between each
scan for failed devices, device state
changes, controller errors, etc. The
number must be an integer.
-S Values = 0 = no scan
1 = scan for failed hot
spares
2 = scan for inactive
online physical devices
3 = both 1 and 2
Default = -S 1
Example = raidbld -S 3
Scan For Failed Devices: Allows
scanning for failed hot spares,
inactive online physical devices, or
both. A value of 0 (or the absence of
the -S parameter in the command
line) will disable this automatic
scanning.
-l Value = [path][filename]
Default = -l [path]raidbld.log
Example = raidbld -l c:\myfile.log
Log All RAIDBLD Information to a
File: If you choose, you may
change the default log file name, or
remove the -l (lowercase L)
parameter to disable logging to a
file.
-c Value = [path][devicename]
Default = OFF (param not set)
Example = raidbld -c /dev/tty07
Display All RAIDBLD Information
on a Console: If you choose, you
may add the path and name of a
console device on which the log
messages will be displayed.
-r Value = none
Default = -r
Example = raidbld -r
Perform Automatic Rebuild:
Initiates a rebuild automatically if a
failed drive is replaced with an
unconfigured, valid drive.
-R Values = 0 = fix errors
1 = do not fix errors
Default = -R 1
Example = raidbld -R 0
Specify Whether or Not Errors
Will Be Fixed Automatically
During Consistency Check: You
can specify whether automatic
consistency check should fix
consistency errors as it finds them,
or leave errors as they are. This
parameter is required in order to
activate background consistency
checking. Set start time and interval
with the parameters below.