Mylex Disk Array controller Software Kit 2.01, Руководство по установке и инструкция пользователя

Страница: 120 / 172

Disk Array Monitor Utility for UnixWare
5-16 Disk Array Controller Software Kit User’s Manual
DAC960TK (Toolkit)
m
Caution
This utility can change the state of the disk array
system and is for use only by experienced computer
technicians and system administrators. Improper use
of this utility may result in system malfunction or
data loss.
Syntax:
# dac960tk
The Toolkit contains several different utilities for controlling the Mylex Disk
Array Controller or for acquiring information. The installation of this utility
is automatic when you install the Global Array Manager Server software.
You can also access the toolkit through the Shell utility described later.
Commands Supported in Toolkit
Inquire. Reports the age of the flash EEPROM, the firmware version
number, the state of the System Drives, and other similar information.
Get Device State. Displays the current state of a selected device.
Start Device. Starts a selected device.
Make Standby. Changes the state of a Dead drive to Standby.
Make Online. Changes the state of a device from Dead to Online.
Kill Device. Changes the state of a selected drive to Dead.
Rebuild Status. Reports the progress of a rebuild operation.
Get Bad-blk-table. Reports the data in either the Write-back Bad Block
Table or the Rebuild Bad Block Table.
Get SCSI Device Info. Reports information on a selected device: e.g.,
device type, vendor and product ID, product revision, or error information.
Get Remap List. Displays the Replacement Table.
Flush. Writes the data from the controller cache to the disk.
System drive info. Reports the mapping of each system drive to the physical
drive.