- Any intervention other than normal cleaning and maintenance by the customer must be carried out by a Moulinex
approved service centre.
- If the cord is damaged, do not use the appliance. In order to avoid any risk, have the cord replaced by an approved
Moulinex service centre (see the list in the service booklet).
- Do not place the appliance, the supply cord or the plug in water or any other liquid.
- Do not leave the supply cord within reach of children.
- The supply cord should never be near to or in contact with hot surfaces, near to a heat source or sharp edges.
- Do not leave the appliance unattended whilst in operation.
- For your own safety, only use the Moulinex accessories and spare parts suitable for your appliance.
- For your safety, this appliance complies with applicable standards and laws:
Low Voltage Directive
Electromagnetic Compatibility
Environment
Materials in contact with foodstuffs.
- Do not use your appliance for more than 14 minutes.
Wash all accessories in soapy water. Rinse, and carefully dry them straight away.
The screen and the cutter must remain greased. Coat them with oil.
Do not use your product when empty if the screens are not greased.
ATTENTION: The blades of the cones are extremely sharp; handle the cones with precaution, always holding them
by the plastic parts.
MINCER HEAD (A):
Assembling the mincer head (diagrams 1.1 and 1.2)
Hold the body
A1
by the feed tube, with the wider opening uppermost. Insert the feed screw
A2
(long shaft first) into
the body
A1
.
Fit the stainless steel cutter
A3
on the short shaft that protrudes from the feed screw
A2
with the cutting edges facing
outwards. Fit the screen of your choice on the cutter
A3
, locating the two lugs in the corresponding two notches in
the body
A1
.
Screw tight (without locking) the nut A5.
Fitting the mincer head to the appliance (diagram 2):
Facing the unplugged motor unit E, insert the mincer head with the feed tube inclined to the right.
Line up the two pins of the mincer head with the two notches of the motor unit.
Push the mincer head home into the motor unit E and then turn the feed tube to the left until it comes to a stop (the
feed tube should now be vertical).
Engage the removable tray B with the lugs on the mincer head feed tube.
Plug the appliance in; it is ready to use.
Use:
Prepare the entire quantity of foodstuffs to be minced, removing bones and gristle. Cut the meat into pieces (approxi-
mately 2 cm x 2 cm).
Place a bowl beneath the mincer head.
Press position “1” of button D to start the appliance, place the pieces of meat on the tray and slide them one by one
into the feed tube with the help of the pusher C.
Never push in the feed tube with the fingers or any other implement.
Tip:
At the end of the operation, you can feed a few pieces of bread into the feed tube to clear any meat remaining in the
machine.
KEBBE ATTACHMENT
Fitting (diagram 3):
Insert the feed screw
A2
into the body
A1
of the mincer head. Fit the kebbe making head F1, locating the lugs in the
USING YOUR APPLIANCE FOR THE FIRST TIME:
BEFORE FIRST USE
2
Notice_2643049A:Mise en page 1 29/10/10 16:23 Page2