Attaching the Mounting Bracket to a Pole
– continued
DEC 2000
3-13
SC
t
300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Procedure to Attach the
Mounting Bracket to a Pole
Follow the procedure in Table 3-7 to attach the mounting bracket to a
pole.
Table 3-7: Procedure for Attaching the Mounting Bracket to a Pole
Step
Action
1
Verify that the isolator pads are in place on the bracket.
2
Verify the safety of the installation location.
3
Place the bucklestrap through the channel clamp as shown in
Figure 3-5.
4
Place the channel clamp and bucklestrap on the pole
approximately where the upper portion of the BTS is to be
located. See Figure 3-5.
5
Slide and center the upper channel extrusion on the channel
clamp. See Figure 3-5.
6
Wrap the bucklestrap around the pole and through the fitting
on the end of the band. Pull the band until it is makes
concentric contact with the pole.
7
Start but do not tighten the lower channel extrusion to the
mounting bracket. Use 2 M6x19 tamper–resistant screws.
8
Before you tighten the lower strap, attach the mounting
bracket to the top channel extrusion.
9
Slide the bucklestrap through the channel clamp and slide the
channel clamp on the lower channel extrusion. Wrap the
bucklestrap around the pole and through the fitting.
10
Secure the bucklestrap with the bucklestrap tool. Refer to the
instructions included with the bucklestrap tool.
11
Use a T30 Torx tamper bit to tighten the six M6x19 screws to
5.0 N–m.
12
Center the channel clamp on to the lower extrusion.
13
Place the bucklestrap through the lower channel clamp.
14
Use the bucklestrap tool to secure the lower strap.
3
