Motorola PMP 320, Установка оборудования

Страница: 86 / 146

5-2 PMP320HDW2v1
Preliminary
JUL 2010
Before you begin Chapter 5: CSM Hardware Installation
Before you begin
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
This section describes items that the installer or subscriber must purchase before installing the
CSM. This section also describes items that must be available and points to consider before
beginning the CSM installation.
Additional material required for installation
The additional materials required for installation are as follows:
•
The computer of the subscriber must be equipped with an Ethernet network interface
card (NIC).
NOTE
The NIC is not provided with the CSM, but subscribers can purchase a NIC at
most computer and electronics stores.
•
An RJ–45 Ethernet cable to connect the CSM plug-in power supply to the computer.
•
Ground wire of sufficient length to run between the CSM and the home ground point.
NOTE
•
It is recommended that the ground wire be a 6 AWG, solid copper wire.
•
It is recommended that if a ground rod is used it should be an 8 ft (2.5m)
copper rod.
•
Most buildings have an existing ground rod outside, at the main power
connection site. If desired, a rod can be installed into the ground outside
the building after consulting the local electrical codes.
•
The AC line cord is not provided with the hardware. Acquire the
appropriate power line cord for the country where the unit is installed.
•
Lead screw anchors if the CSM is mounted on a brick or masonry surface.
•
Outdoor-rated category 5e Ethernet cable to connect the CSM plug-in power supply
through the building wall to the CSM.
•
RJ–45 plug connectors and the tools required for field termination of the category 5e cable
•
Grommet to cover a 3/4 inch. (18 mm) hole
•
Silicone or acrylic caulking