Motorola PMP 320, Установка оборудования

Страница: 110 / 146

6-8 PMP320HDW2v1
Preliminary
JUL 2010
Installation Overview Chapter 6: Connectorized CSM Hardware Installation
Installation Overview
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
After finding the best installation location on the building, perform the following procedure
to install the CSM.
Procedure 6-2 Installing the Connectorized CSM
1 Complete the mounting bracket assembly; leave the screws on the bracket
arm slightly loose. If the screws are too tight, the vertical and horizontal tilt
of the CSM cannot be adjusted later.
NOTE
If fastening the CSM to a pole, add the pole clamp to the assembly.
Otherwise, set the pole clamp aside.
2
Perform one of the following:
1.
If attaching the CSM to the side of a building, attach the CSM to the
building using the wall bracket of the bracket assembly.
2.
Mount the CSM to a pole using the wall bracket and pole clamp of the
bracket assembly.
3
Adjust the vertical and horizontal tilt of the CSM so that it can obtain the
best signal.
4
Fully tighten the bracket assembly into the desired position.
Completing the mounting bracket assembly
Perform the following procedure to complete the mounting bracket assembly. Refer to
Figure 6-3 to reference the brackets and the assembly of the brackets.
Procedure 6-3 Mounting bracket assembly
1
Attach one end of the bracket arm to the arch on this wall bracket.
2
Insert a 5/16×1½ hex bolt into the arch of the wall bracket that was attached
to the CSM in
step 1 . Ensure that the head of the medium hex bolt rests
inside the bolt jam of the arch.
3 Guide the rest of the bolt through the arch of the wall bracket.
4
Slide a tooth lock washer on the end of the hex bolt.
5
Align the hole on one tab of the bracket arm with the end of the bolt.
Continued