PMP 320 Hardware Installation
Omni Directional Base Station Antenna
PMP320HDW2v1
7-29
JUL 2010
Preliminary
1
Locate the area of the pole where the Omni Directional Base Station Antenna
will be mounted to the pole.
2
Slide the U-bracket around the pole.
3
Align the Omni Directional Base Station antenna bracket and pass the
U-bracket through the bracket of the antenna.
4
Slide the plain washers on the U-bracket.
5
Slide the helical locking washers on the U-bracket
6
Use the nuts to securely fasten the antenna bracket to the U-bracket
7
Repeat
step 2
through step
step 6
for the second bracket. Repeat these steps
for the second antenna.
8
Connect the antenna to the connectorized CSM using the instructions in the
Antenna Mounting Instructions
Use the following procedure to mount the Omni Directional Base Station Antenna to a pole.
Note that two Omni Directional Base Station Antennas are needed to support the Connectorized
PMP 320 CSM.
Figure 7-6 Omni Directional Base Station Antenna Bracket Identification
G1_omnipolemntbracketconn.eps
Procedure 7-2 Procedure to mount an Omni Directional Base Station Antenna to a
pole
Connectorized CSM Installation chapter.
Содержание PMP 320
