2-2
PMP320HDW2v1
Preliminary
JUL 2010
CD
Guide
Installing the AP Hardware
Chapter 2: AP Hardware Installation
Installing the AP Hardware
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
General communications equipment, infrastructure, and facilities site design should be
performed in line with Motorola’s
Standards and Guidelines for Communications Sites
(also known as the
R56
manual) available from:
https://motorolawls.
motolms.com/Secure/Course_Description.asp?number=ANT001-
.
A short coaxial cable from the radio terminates in a male N connector. The antenna has a
chassis-mounted female N connector. The antenna includes tower mount brackets with
adjustable down-tilt.
Installing an AP typically consists of the following phases:
1.
Configure the AP at an operator's facility or at the installation site using the information
and settings defined in the
Planning and Configuring
sections of the
PMP 320
Administration and Configuration
.
2.
Assemble the AP (radio, antenna, and brackets) and physically install it using
Procedure 2-1
. A CMM4 is typically installed at the same time, if not previously installed.
3.
Cable the AP to the CMM4 and ground it to Protective Earth – PE using
Procedure 2-2
.
4.
This phase can also include cabling to backhauls, or running terrestrial feeds.
5.
Confirm operation, using CSMs in the field.
Local practices and choices of installation options will dictate the actual processes. For example,
variations on these generalized procedures can be used to install on a building or install multiple
APs on a pipe mount before hoisting up a tower for final attachment.
Assembling the AP and attaching to a tower
Review the following parts identification graphics to ensure that all the top pipe clamp assembly
brackets parts are present before beginning the installation. Refer to
Figure 2-1
and
Figure 2-2
to see the parts that make up the antenna and AP.
The parts consist of:
Содержание PMP 320
