Engine servicing
3-6
3-6
(1) FUEL RETURN HOSE
(1) SEALING WASHER
(2) BANJO BOLT
(1) 2P CONNECTOR
Fuel Pump Flow Inspection
Remove the seat, front covers, side covers and the seat-
rear fender assy.
Disconnect el banjo bolt and insert the eyelet of the hose
in a homologated fuel container.
Raise the fuel tank.
Connect the 12 V battery to the fuel pump 2P connector
terminals, check amount of fuel flow for 10 seconds.
Amount of flow:
0.749 l/min (125 cm
3
/ minumun 10 seg)
If the fuel flow is less than specified, inspect the following:
– Pinched or clogged fuel hose
– Clogged fuel filter
– Fuel pump (page 3-7)
After inspection, re-insert the banjo bolt in the fuel feed
hose using a new sealing washer.
Torque: 22 N•m (2,2 kgf•m, 16,2 lbf•ft)
Connect the fuel pump 2P connector.
Start the engine and check for fuel leaks.
1
1
1
1
2
Содержание 4Ride MST260 2016
