Montesa 4Ride MST260 2016, Руководство по ремонту

Страница: 116 / 158

4-8 4-8
Frame servicing
(1) FORK TUBE
(2) CILINDER ASSY
(3) TAPERED BUSHING
(4) FORK SLIDER
Remove the tapared bushing from the cilinder assy.
NOTICE
Be careful not to damage the tapared bushing.
Remove the cilinder assy from the fork tube.
Remove the following items using the same procedure as
the right fork disassembly (page 4-2):
– Oil seal
– Back-up ring
– Guide bushing
– Fork tube bushing
Hold the axle holder in a vise protected with a piece of
wood or soft jaws to avoid damage.
Do not overtighten.
Hold the cylinder assembly using the special tool and
tighten the central screw to the specified torque.
Tool:
Fork damper holder 07930-KA50100
Remove the center bolt and sealing washer.
Remove the following items using the same procedure as
the right fork disassembly (page 4-2):
– Dust seal
– Stop ring
– Fork tube, unlocking guide bushing on the fork leg.
(1) CILINDER ASSY
(2) CENTER BOLT
(1) FORK BOLT
(2) DISTANCE COLLAR
(3) SPRING SEAT
(4) FORK SPRING
(5) TAPERED BUSHING
(6) FORK TUBE
Left Fork Disassembly
Before disassembling the fork, clean the entire sliding
surface and the bottom of the fork slider.
Be careful not to scratch the fork tube.
A scratched fork tube will damage the seal, causing an
oil leak.
The fork bolt under spring pressure.
Before removing the fork bolt, turn the pre-load adjuster
softest position.
Remove the fork bolt from the fork tube.
Remove the tapared bushing, distance collar, spring seat
and fork spring.
Pour out the fork fluid.
3
4
2
1
4
3
6
2
1
5
2
1