Montesa 4Ride MST260 2016, Руководство по ремонту

Страница: 135 / 158

4-27 4-27
Frame servicing
(1) OIL BOLT
(2) MOUNTING BOLTS
(3) BRAKE CALIPER
Front brake caliper
Removal
NOTICE
Avoid spilling brake fl uid on painted, plastic or rubber
parts.
Place a shop rag over these parts whenever the system
is serviced.
Drain the brake system.
Place a clean container under the caliper.
Remove the following:
– Brake hose oil bolt
– Sealing washers
– Brake hose eyelet
– Caliper mounting bolts
– Flange collars
– Brake caliper
– Spring pin for the pads
– Brake pads (page 4-24)
Rear brake caliper
Removal
NOTICE
Avoid spilling brake fl uid on painted, plastic or rubber
parts.
Place a shop rag over these parts whenever the system
is serviced.
Drain the brake system.
Place a clean container under the caliper.
Remove the following:
– Brake hose oil bolt
– Sealing washers
– Brake hose eyelet
– Rear wheel (page 4-14)
– Brake caliper/bracket
– Spring pin for the pads
– Brake pads (page 4-25)
(1) OIL BOLT / STOP SWITCH
(2) BRAKE HOSE
(3) BRAKE CALIPER
Inspection
Clean the inside of the caliper.
Check the oil leakage from the caliper cylinders.
If any part of the caliper is damaged, replace the caliper
as an assembly.
Installation
Apply locking agent to the caliper mounting bolt threads.
Install the brake caliper and disc cover, and then install
and tighten the caliper mounting bolts.
Torque: 26 N•m (2.7 kgf•m, 20 lbf•ft)
Connect the brake hose eyelet joint with two new sealing
washers, then tighten the oil bolt.
Torque: 27 N•m (2.8 kgf•m, 20 lbf•ft)
3
2
2
1
3
2
1