Montesa 4Ride MST260 2016, Руководство по ремонту

Страница: 115 / 158

4-7 4-7
Frame servicing
(1) FORK DAMPER ROD
(2) OIL LEVEL
2. Pump the damper rod 8 - 10 times.
3. Make sure no air in fork damper by slowly pull the
damper rod up. If the resistance is felt at the top end,
pump the damper rod again.
Wait 2 – 3 minutes before measuring the oil level.
Measure the oil level from top of the fork tube, with the
fork fully compresed.
Standard oil level: 60 mm (2.36 in)
Oil capacity (orientative): 385 cm
3
(13.0 US oz)
(13.5 Imp oz)
Pour recommended fork fluid in the fork leg.
Specified fork fluid: Tech OJ01 (SAE 5)
Bleed the air as follows:
1. Extend the fork without bringing to its maximum exten-
sion. Cover the top of the fork tube with your hand and
compress the fork slowly several times.
NOTICE
Totally extended fork may cause oil leakage.
(1) FORK FLUID
(2) FORK TUBE
Install a new O-ring onto the fork bolt groove.
Screw the fork bolt on the lock nut from the damper rod
until it seats.
Hold the lock nut and tighten the fork bolt to the specified
torque.
Torque: 14,7 N•m (1,49 kgf•m)
Apply recommended fork fluid to the O-ring, then screw
the fork bolt into the fork tube.
Torque: 12,7 N•m (1,3 kgf•m)
(1) LOCK NUT
(2) NEW O-RING
(3) FORK BOLT
2
1
1
2
3
2
1
2
3
1