Montesa 4Ride MST260 2016, Руководство по ремонту

Страница: 126 / 158

4-18 4-18
Frame servicing
Spherical Bearing Replacement
Remove the collars and dust seals.
Check the spherical bearing for smooth rotation or
damage.
Remove the stop ring
Press the spherical bearing out using the special tool.
Tool:
Spherical bearing driver 07HMF-KS60100
Press a new spherical bearing into the shock absorber
pivot until its seats using same tool.
Install the new stop ring into the groove.
Apply grease to the dust seal lips.
Install the dust seals and collars.
(1) DUST SEALS
(2) SPHERICAL BEARING
(1) PRE-LOAD LENGTH
(2) ADJUSTER
(3) LOCK NUT
Adjust the spring pre-load length (page 1-4).
Hold the spring adjuster and tighten the lock nut to the
specified torque.
Torque:
Tightening angle 50°±10 after contact between nuts
(1) DISTANCE COLLAR
Remove the distance collar.
Remove the stopper ring, spring seat and spring.
Inspection
Check the following items:
– Upper and lower spherical bearing for wear or damage
– Spring for damage and measure the free length
– Damper for oil leakage from the damper rod
Replace the damper unit if an oil leak is detected.
1
1
1
1
1
2
2
2
2 3
1
1