Montesa 4Ride MST260 2016, Руководство по ремонту

Страница: 155 / 158

5-15 5-15
Electrical servicing
If there is no voltage, check the following:

Open circuit in the Black wire between the ignition
relay and the connector 9P (white) on the handlebar.
If there is voltage, check the continuity between the
terminals in each switch position, as shown in the table.
Horn
Checks:
If the engine starts but the horn does not work, check the
following:

Loose connection.
If there is no loose connector, disconnect the connectors
from the horn.
Connect the 12 V battery to the horn’s terminals. If the
horn does not sound, replace it with a new unit and re-
peat the test.
If the horn sounds, do the following procedure:
Start the engine and check the voltage between the
following terminals of the connector 9P (white) on the
harness side:
Connection: Black (+) and Ground (–)
Standard: 12V approximately.
(1) HORN
(2) CONNECTORS
(1) HOUSING FOR THE UPPER HEADLIGHT
(2) CONNECTOR 6P
(3) CONNECTOR 3P
Checking the speed sensor
Remove the housing for the upper headlight.
Check if there are loose or defective contacts in the
connector 3P (white) of the speed sensor.
Disconnect the connector 3P (white) of the speed sensor.
Start the engine.
Measure the voltage between the terminals of the
connector 3P (white) of the speedometer on the wire side.
Connection: Red (+) and Blue (–)
Standard: 5V approximately.
If the standard voltage appears, replace the speed sensor.
If there is no standard voltage, check the following:

The blue wire in case there is an open circuit.

The red wire in case there is an open circuit.
 Speedometer.
G
FREE
PUSH
COLOR LG
Po GND
INTERRUPTOR DE LA BOCINA
BATERÍA BATERÍA
HORN SWITCH
BATTERY
2
1
3
1
2