App. - 46 App. - 46
MELSEC-Q
APPENDIXES
Appendix 9.6 When clearing received data
The following program example uses the receive data clear request area of the buffer
memory.
Refer to Section 6.1.4 for received data clear.
(1) Program conditions
The following program clears the received data in the OS area of the QJ71C24N
when the receive clear command (X1025) turns ON.
(a) Devices used
:
• Receive clear command ......................................................... X1025
• Receive clear processing execution command...................... M10
• Receive clear command pulse signal..................................... M15
• Receive clear acceptance flag................................................ M16
• Receive clearing flag............................................................... M17
• Communication disable flag.................................................... M18
• Communication enable flag .................................................... M19
• Completion check flag............................................................. M20
• Receive clear processing execution status acquisition
command ................................................................................ M21
• Receive clear processing execution status judgment
command ................................................................................ M22
• Completion device for REMFR/REMTO instruction ............... M100 to 103
• Normal/abnormal completion flag for REMFR/REMTO
instruction................................................................................ M200, M201
• Receive data clear request area information.......................... D0
• Clear request........................................................................... D1
(b) Intelligent function module switch settings (Refer to Section 4.5.2)
Bit
Switch No.
Position Designated
value
Description
Setting
value
b0 OFF
Operation
setting
Independent
b1
OFF
Data bit
7 bits
b2 OFF
Parity
bit
No
b3 OFF
Even/odd
parity
Odd
b4
OFF
Stop bit
1 bit
b5
OFF
Sum check code
No
b6
ON
Write during RUN
Enabled
b7 ON
Transmission
setting
Setting modifications
Enabled
Switch 1
b8 to b15
—
Communication rate setting
19200bps
07C0
H
Switch 2
—
Communication protocol setting
Non-procedure protocol
0006
H
Switch 5
—
Station number setting
Station 0
0000
H
(c) Buffer memory settings used in this example
Address Decimal (Hexadecimal)
CH1
Name
Setting
value
168 (A8
H
)
Receive data clear request
0, 1
Содержание MELSEC QJ71C24
