Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 787 / 1164

BODY -
Window Glass
42-15
INSTALLATION SERVICE POINTS
"
A
A
WINDSHIELD UPPER MOULDING/WINDOW
SPACER/GLASS STOPPER/WINDSHIELD
INSTALLATION
1. When replacing the windshield, temporarily set the
windshield against the body, and place a mating mark
on the windshield and body.
2. Use isopropyl alcohol to degrease the inside and outside
of the windshield and the body flanges.
3. Soak a sponge in the primer, and apply evenly to the
windshield and the body in the specified places.
4. Apply the primer, and then let it dry for 3 to 30 minutes.
Caution
(1) The primer strengthens the adhesive, so be sure
to apply it evenly around the entire circumference.
However, a too thick application will weaken the
adhesive.
(2) Do not touch the coated surface.
5. Install the windshield upper moulding to the windshield.
6. Place the window spacer to the windshield so that it
inclines toward the windshield and its right and left
clearances are equal. Then install the spacer firmly so
that it is not adrift.
7. Install the glass stopper to the shown dimension.
8. Fill a sealant gun with adhesive. Then apply the adhesive
evenly around the windshield within 30 minutes after
applying the primer.
NOTE
Cut the tip of the sealant gun nozzle into a V shape
to simplify adhesive application.
9. After applying the adhesive, align the mating marks on
the windshield and the body, and then press the windshield
gently to seat it.
10. Use a spatula or the like to remove any excessive
adhesive. Then clean the surface with isopropyl alcohol.
Install the roof drip moulding before the adhesive hardens.
11. Try not to move the vehicle until the adhesive sets. Wait
30 minutes or more, and then test for water leakage.
Caution
(1) Do not move the vehicle unless absolutely
necessary.
(2) When testing for water leakage, do not pinch the
end of the hose to spray the water.
19.6 mm
300 mm
Centre
Glass stopper
Section A - A
Glass stopper
300 mm
A
A
10 mm
15 mm