Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 1008 / 1164

SRS -
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-54
Front passenger’s side air bag module
(1) Remove the front passenger’s side air bag module
from the vehicle. (Refer to P.52B-33.)
Caution
The front passenger’s side air bag module should
be stored on a flat surface and placed so that
the air bag deployment surfaces are facing
upward. Do not place anything on top of them.
(2) Connect two wires, each six meters or longer, to the
two leads of SRS air bag adapter harness and cover
the connections with insulation tape. The other ends
of the two wires should be connected to each other
(short-circuited), to prevent sudden unexpected
deployment of the front passenger’s side air bag.
(3) Take the SRS air bag adapter harness that is
connected to the wires, pass it beneath the old tyre
wheel assembly, and connect it to the front
passenger’s side air bag module.
(4) Pass thick wire through the holes in the front
passenger’s side air bag module bracket. With the
deployment side upwards, secure the front
passenger’s side air bag module to the wheel of the
old tyre.
Caution
1) Slack the deployment wires below the wheel.
If deployment wires are tight, the reaction
when the air bag deploys could damage the
adaptor harness.
2) The connector of the SRS air bag adapter
harness should be placed so that it is not
clamped by the tyres during deployment or
operation.
(5) Place three old tyres, without wheels, on top of the
tyre secured to the front passenger’s side air bag
module, and secure all tyres with ropes (4 locations).
SRS air bag
adapter harness
MR686560
Connection
6 m long
or more
Insulation tape
Deployment wires
Front passenger’s side air bag module
Deployment
wires
Tyres without wheels
Deployment wire