Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 586 / 1164

REAR AXLE <4WD> -
Drive Shaft
27B-14
REASSEMBLY SERVICE POINTS
"
A
A
B.J. BOOT/D.O.J. BOOT INSTALLATION
1. Wrap a plastic tape around the spline of the drive shaft,
and then remove the B.J. boot and D.O.J. boot in that
order.
2. Fill the specified grease inside the B.J. and B.J. boot.
Specified grease: Repair kit grease
Amount to use:
<Vehicles without ABS> 75 g
<Vehicles with ABS> 145 g
NOTE
The grease in the repair kit should be used once at a
time. One-half of the grease should be filled in the joint,
the remaining one-half filled inside the boot.
Caution
The drive shaft joint uses special grease. Do not mix
old and new grease or different types of grease.
3. Tighten the boot band.
Caution
(1) In order to maintain air inside the B.J. boot
properly, the drive shaft should be maintained
at 0 degree joint angle while the band is tightened.
(2) Before tightening the B.J. boot band or D.O.J.
boot band, make sure that the boot band is correct
by identification number stamped on the lever.
Identification numbers of the boot bands
Item Vehicles
without ABS
Vehicles with
ABS
B.J. boot band large 20-110#BJ87 20-75#BJ95
small 20-83#BJ82 20-111#BJ87
D.O.J. boot band large 20-82#BJ82 20-82#BJ82
small 20-83#BJ82 20-83#BJ82
"
B
A
D.O.J. CAGE/D.O.J. INNER RACE INSTALLATION
1. Assemble the D.O.J. cage in the drive shaft, and slide
it to the B.J. assembly side.
2. Align the mating marks on the D.O.J. inner race and
the shaft.
3. Use the special tool to press in the inner race to the
shaft projection evenly and gently.
Lever
MB990939
Mating marks