Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 506 / 1164

AUTOMATIC TRANSMISSION -
On-vehicle Service
23-46
9. Reconnect the hose which was disconnected in step 1
above, and firmly replace the oil level gauge.
10. Start the engine and run it at idle for 1 - 2 minutes.
11. Move the selector lever through all positions, and then
move it to the N position.
12. Check that the fluid level is at the COLD mark on the
oil level gauge. If the level is lower than this, pour in
more fluid.
13. Drive the vehicle until the fluid temperature rises to the
normal temperature (70 - 80 _ C), and then check the
fluid level again.
The fluid level must be at the HOT mark.
NOTE
The COLD level is for reference only; the HOT level should
be regarded as the standard level.
14. Firmly insert the oil level gauge into the oil filler tube.
AUTOMATIC TRANSMISSION FLUID COOLER LINE
FLUSHING
23101300070
Caution
When the transmission has been replaced or overhauled,
or automatic transmission fluid is contaminated, the
transmission fluid cooler line flushing should always be
carried out.
1. Disconnect the hose shown in the illustration which
connects the transmission and the oil cooler (inside the
radiator).
2. Start the engine and let the fluid drain out.
Caution
The engine should be stopped within one minute after
it is started. If the fluid has all drained out before
then, the engine should be stopped at that point.
Discharge volume: Approx. 3.5 L