Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 1002 / 1164

SRS -
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-48
(3) Connect two wires, each six meters or longer, to the
two leads of SRS air bag adapter harness and cover
the connections with insulation tape. The other ends
of the two wires should be connected to each other
(short-circuited), to prevent sudden unexpected
deployment of the front passenger’s side air bag.
(4) Connect the SRS air bag adapter harness to the
front passenger’s side air bag module 2-pin connector
(red) and pull the deployment wires out of the vehicle.
(5) Fully close all door windows, close the doors and
place a cover over the vehicle to minimize the amount
of noise.
Caution
If the glass is damaged, it may break, so the car
must be covered.
(6) Disconnect the deployment wires as far from the
vehicle as possible and connect the wires to the
terminals of the battery removed from the vehicle.
Deploy the front passenger’s side air bag module.
Caution
1) Before deploying the air bag in this manner,
first check to be sure that there is no one
in or near the vehicle. Wear safety glasses.
2) The deployment of the front passenger’s side
air bag makes the inflator very hot. Before
handling the inflator,wait more than 30 minutes
for cooling.
3) If the air bag module fails to deploy when the
procedures above are followed, do not go near
the module. Contact your local distributor.
(7) After deployment, dispose of air bag module according
to the Deployed Air Bag Module and Seat Belt
Pre-tensioner Disposal Procedures. (Refer to
P.52B-58.)
SRS air bag
adapter
harness
MB686560
Connection
6 m or longer
Insulation
tape
Deployment wires
SRS air bag
adapter
harness
MB686560
Front passenger’s side air bag
module 2-pin connector (red)
Deployment wires
Cover
Deployment wires