Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 602 / 1164

REAR AXLE <4WD> -
Differential Carrier
27B-30
REASSEMBLY SERVICE POINTS
"
A
A
OIL SEAL INSTALLATION
1. Use the special tool to press in the new oil seal fully.
2. Lightly apply multipurpose grease to the oil seal lip.
"
B
A
DRIVE PINION REAR BEARING OUTER
RACE/DRIVE PINION FRONT BEARING OUTER
RACE INSTALLATION
Caution
Be careful to press in the outer race straight, otherwise
the outer race will be damaged.
"
C
A
DRIVE PINION HEIGHT ADJUSTMENT
Adjust the drive pinion height by the following procedures:
1. Apply a thin coat of the multipurpose grease to the mating
face of the washer of the special tool.
2. Install special tools and drive pinion front and rear bearing
inner races on the gear carrier in the sequence shown
in the illustration.
3. Gradually tighten the nut of the special tool while checking
to drive pinion turning torque until the standard value
of drive pinion turning torque is obtained.
Standard value:
Bearing
division
Bearing lubrication Turning
torque Nm
New None
(with anti-rust agent)
0.9 - 1.2 Nm
New or reusing Gear oil applied 0.4 - 0.5 Nm
NOTE
Because the special tool cannot be turned one turn, turn
it several times within the range that it can be turned;
then, after fitting to the bearing, measure the rotation
torque.
MB990938
MB991115
MB990938
FRONT BEARING
MB990938
REAR BEARING
MB990932
MB990935
Washer
MB990836
(MB990835)
MB990836
MB990326