Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 1009 / 1164

SRS -
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-55
(6) Disconnect the deployment wires as far from the front
passenger’s side air bag module as possible and
connect the wires to the battery removed from the
vehicle.
Caution
1) Before the deployment, be sure that no one
is near the front passenger’s side air bag
module.
2) The deployment of the front passenger’s side
air bag makes the inflator very hot. Before
handling the inflator, wait more than 30
minutes for cooling.
3) If the front passenger’s side air bag module
fails to deploy when the procedures above
are followed, do not go near the module.
Contact your local distributor.
(7) After deployment, dispose of air bag module according
to the Deployed Air Bag Module and Seat Belt
Pre-tensioner Disposal Procedures. (Refer to
P.52B-58.)
Side air bag module
(1) Remove the front seat back assembly with the side
air bag from the vehicle. (Refer to P.52B- 33.)
Caution
The side air bag module should be stored on a
flat surface and placed so that the air bag
deployment surfaces are facing upward. Do not
place anything on top of them.
(2) Connect two wires, each six meters or longer, to the
two leads of SRS air bag adapter harness and cover
the connections with insulation tape. The other ends
of the two wires should be connected to each other
(short-circuited), to prevent sudden unexpected
deployment of the side air bag.
(3) Place the front seat back assembly so that its back
contacts the ground.
(4) Connect the SRS air bag adapter harness connected
with the deployment wires to the side air bag module
connector.
Deployment wires
SRS air bag
adapter harness
MR686560
Connection
6 m long
or more
Insulation tape
Deployment wires
SRS air bag adapter harness
MR686560
Front seat back assembly