Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 530 / 1164

AUTOMATIC TRANSMISSION -
Transmission Assembly
AUTOMATIC TRANSMISSION -
Transmission Assembly
23-70
REMOVAL SERVICE POINTS
A
A
"
TIE ROD END DISCONNECTION
Caution
1.
Use the special tool to loosen the tie rod end mounting
nut. Only loosen the nut; do not remove it from the
ball joint.
2. Support the special tool with a cord, etc. not to let
it come off.
A
B
"
STEERING GEAR AND LINKAGE MOUNTING
BOLT REMOVAL
Remove the steering gear and linkage mounting bolts, and
then support the steering gear box to the vehicle body with
a wire.
A
C
"
DRIVE SHAFT DISCONNECTION
1. Position a hammer under the projection, and then use
a prybar to pry the drive shaft from the transfer case.
Caution
(1) Always use a pry bar to withdraw the drive shaft.
Pulling out the drive shaft forcibly from the B.J.
assembly may damage the T.J. assembly.
(2) Be careful not to damage the oil seal of the
transmission or transfer by the spline of the drive
shaft.
2. Suspend the removed drive shaft with a wire to a nearby
part so that there are no sharp bends in any of the joints.
3. Use a shop towel to cover the transmission case not
to let foreign material get into it.
A
D
"
TRANSMISSION MOUNT BRACKET REMOVAL
Carefully lower the transmission assembly with a garage jack,
and remove the transmission mount bracket.
A
E
"
ENGINE AND TRANSMISSION ASSEMBLY
SUPPORTING
Set the special tool to the vehicle to support the engine and
transmission assembly.
Cord
Ball joint
MB990635 or
MB991113
Nut
Drive shaft
Transmission case
Hammer
Prybar
Projection
MZ203827
MB991453