Mitsubishi MOTORS Space Runner 1998, Руководство по ремонту

Страница: 1001 / 1164

SRS -
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-47
(5) Fully close all door windows, close the doors and
place a cover over the vehicle to minimize the amount
of noise.
Caution
If the glass is damaged, it may break, so the car
must be covered.
(6) Disconnect the deployment wires as far from the
vehicle as possible and connect the wires to the
terminals of the battery removed from the vehicle.
Deploy the driver’s side air bag module.
Caution
1) Before deploying the air bag in this manner,
first check to be sure that there is no one
in or near the vehicle. Wear safety glasses.
2) The deployment of the driver’s side air bag
makes the inflator very hot. Before handling
the insulator, wait more than 30 minutes for
cooling.
3) If the air bag module fails to deploy when the
procedures above are followed, do not go near
the module. Contact your local distributor.
(7) After deployment, dispose of air bag module according
to the Deployed Air Bag Module and Seat Belt
Pre-tensioner Disposal Procedures. (Refer to
P.52B-58.)
Front passenger’s side air bag module
(1) Remove the glove box. (Refer to GROUP 52A -
Instrument panel.)
(2) Remove the connection between the front
passenger’s side air bag module 2-pin connector (red)
and the instrument panel wiring harness connector
(2-pin).
NOTE
If the front passenger’s side air bag module connector
is disconnected from the instrument panel wiring
harness, both electrodes of the front passenger’s side
air bag module connector will be automatically shorted
to prevent unintended deployment of the front
passenger’s side air bag due to static electricity, etc.
Cover
Deployment wires
Front passenger’s side air bag
module 2-pin connector (red)
Instrument panel
wiring harness
connector (2-pin)