TM_s-MEXT_ME28relC_00_12_19_EN
Technical manual
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
17
Mask of the terminal
Description
ACTIVE FUNCTIONS
DELAY FOR TIME
OBSERVATION
Mask that displays the active functions of the unit
Visible only when certain functions are active
24.0 °C 15.0 °C
35.0 °C
Active probe value display mask
•
Return temperature probe
•
Delivery temperature probe
•
External temperature probe
AUXILIARY T-H PROBE
Addr. 129
24.0 °C
50.0 %
Status:Offline
Mask that displays the value of the serial auxiliary probe (address 129).
Visible if the probe is configured
REQUEST STATUS
Cooling request: 100%
Step request: 11
Waiting: NONE
Mask displaying the requests of cold and steps sent to the PCA-IF013B-E card
It also shows if the system is waiting for the expiry of a time delay before sending the steps to the Master PAC-IF013B-E card:
•
[NONE]
No delay
•
[SHORT WAIT]
Short delay (300s / 5min)
•
[LONG WAIT]
Long delay (600s / 10min)
•
[CHANGING MODE]
Cycle inversion/mode change (120 s / 2min)
•
[MIN T.OFF]
Minimum Off (120s / 2min)
PAC-IF013B-E MASTER
Active step: 11
Mode: COOLING
Status:Online
Master PAC-IF013B-E status
Pressing [
ENTER
] will take to the section containing additional Master PAC-IF card information
In case of alarm, the
icon will flash showing the “PAC
-
IF code:” message followed by the alarm code from the PAC
-IF card.
For additional information on the meaning of the code, see the “Event Mask” ch
apter.
PAC-IF013B-E SLAVE1
Active step: 11
Mode: COOLING
Status:Online
Slave 1 PAC-IF013B-E status
Pressing [
ENTER
] will take to the section containing additional Slave 1 PAC-IF card information
In case of alarm, the
icon will flash showing the “PAC
-
IF code:” message followed by the alarm code from the PAC
-IF card.
For additional information on the meaning of the code, see the “Event Mask” chapter.
0 08.0bar 08.0bar
03.3°C 03.3°C
Mask for the display of the values of the active probes and their conversions into temperature
•
Circuit 1 low pressure switch
•
Circuit 2 low pressure switch
LAN 1: 2: 3:
4: 5: 6:
7: 8: 9:
10:
Visible if the local network (LAN) is configured
Local network (LAN) status display mask. This mask is displayed only at the Master
unit (LAN address=1).
Unit operating
Unit in stand by
Unit in rescue mode
Unit not operating
Unit with Hot-Spot protection
Unit with Cold-Spot protection
When enabled it is possible to view the status of the ADL LAN function:
•
ADL enabled
ADL operating limit reached
