Mitsubishi Electric MELSERVO-JN Series, Инструкция по эксплуатации

Страница: 336 / 480

12 - 33
12. SERVO MOTOR
(c) Permissible loads of servo motor shaft
The permissible radial load in the table is the value measured at the center of the reduction gear output
shaft.
Q/2
Q
Q: Length of axis
(Refer to section 6.8.3, 6.8.4 in the Servo Motor
INSTRUCTION MANUAL (Vol.2).)
Servo motor Reduction ratio
Permissible load (Note)
Permissible radial
load
Permissible thrust
load
[N] [Ib] [N] [Ib]
1/5 150 33.7 200 45.0
HF-KP053G1 1/12 240 54.0 320 71.9
1/20 370 83.2 450 101
1/5 150 33.7 200 45.0
HF-KP13G1 1/12 240 54.0 320 71.9
1/20 370 83.2 450 101
1/5 330 74.2 350 78.7
HF-KP23G1 1/12 710 160 720 162
1/20 780 175 780 175
1/5 330 74.2 350 78.7
HF-KP43G1 1/12 710 160 720 162
1/20 760 171 760 171
Note. Do not subject the shaft to load greater than this value.
The values in the table are applicable when the loads are applied independently.