Mitsubishi Electric MELSERVO-JN Series, Инструкция по эксплуатации

Страница: 150 / 480

4 - 53
4. PARAMETERS
No. Symbol Name and function
Initial
value Setting
range
Unit
Control mode
Position
Internal
speed
Internal
torque
PD20 *DOP1 Function selection D-1
Select the stop processing at forward rotation stroke end
(LSP)/reverse rotation stroke end (LSN) OFF, the base circuit status
at reset (RES) ON and the operation during tough drive (MTTR).
How to make a stop when forward rotation stroke
end (LSP)/reverse rotation stroke end (LSN)
is OFF. (Refer to Section 4.4.3.)
0: Sudden stop
1: Slow stop
0
Selection of base circuit status at reset (RES) ON
0: Base circuit switched off
1: Base circuit not switched off
Operation selection during tough drive (MTTR)
0: MTTR turns ON during the instantaneous
power failure tough drive.
1: MTTR turns ON during the overload tough
drive or the instantaneous power failure tough
drive
0000h Refer to
the name
and
function
field.
PD21 For manufacturer setting
Do not change this value by any means. 0000h
PD22 *DOP3 Function selection D-3
Set the clear (CR).
Clear (CR) selection
0: Droop pulses are cleared on the leading edge.
1: While on, droop pulses are always cleared.
0 0 0
0000h Refer to
the name
and
function
field.
PD23 For manufacturer setting
Do not change this value by any means. 0000h
PD24 *DOP5 Function selection D-5
Select the warning (WNG) outputs.
0 0
Selection of output device at warning occurrence
Select the warning (WNG) and trouble (ALM)
output status at warning occurrence.
0
1
Setting
0
1
0
1
WNG
ALM
Warning occurrence
0
1
0
1
WNG
ALM
Warning occurrence
(Note) Device status
Note. 0: off
1: on
0
0000h Refer to
the name
and
function
field.