Mitsubishi Electric MELSERVO-J5 MR-J5-G Series, Руководство пользователя

Страница: 66 / 478

64
3 SIGNALS AND WIRING
3.3 Explanation of power supply system
Connecting wires
■
Fabricating the wire insulator
Refer to the following for the stripped length of the wire insulator. Set the appropriate length based on the wire type and
fabrication condition.

Page 61 Connector
Twist the core wires lightly and straighten them as follows.
A ferrule can also be used when connecting to the connectors. If using a ferrule, choose from one of the ferrules and the
crimping tools shown below.
■ Inserting wire
Insert only one wire or ferrule into each wire insertion hole on each power connector.
Insert the open tool as follows and push it down to open the spring.
While the open tool is pushed down, insert the stripped wire into the wire insertion hole. Check the wire insertion depth so that
the wire insulator is not caught by the spring and that the conductive part of the stripped wire is not exposed.
Release the open tool to fix the wire. Pull the wire lightly to confirm that the wire is surely connected. In addition, confirm that
the ends of the core wires do not stick out of the connector.
Servo amplifier Wire size Ferrule model (Phoenix Contact) Crimping tool (Phoenix
Contact)
For one wire For two wires
MR-J5-10_ to
MR-J5-100_
MR-J5W2-_G_
MR-J5W3-_G_ AWG 16 AI 1,5 -10 BK AI-TWIN 2X 1,5 -10 BK CRIMPFOX-ZA3
AWG 14 AI 2,5 -10 BU

MR-J5-200_ to
MR-J5-350_ AWG 16 AI 1,5 -10 BK AI-TWIN 2X 1,5 -10 BK
AWG 14 AI 2,5 -10 BU AI-TWIN 2X 2,5 -10 BU
AWG 12 AI 4 -10 GY

MR-J5-500_ AWG 10 Al6-12 YE

MR-J5-700_ AWG 8 Al10-12 RD

CRIMPFOX-25R
MR-J5-60_4_ to
MR-J5-350_4_ AWG 16 AI 1,5 -10 BK AI-TWIN 2X 1,5 -10 BK CRIMPFOX-ZA3
AWG 14 AI 2,5 -10 BU

Insulator
Core
Stripped length
Twist and straighten the strands. Loose and bent strands
(1) Push down the open tool.
(3) Release the open tool to fix the wire.
(2) Insert the wire.