Mita PointSource Ai 3010, Руководство по обслуживанию

Страница: 319 / 478

2AR
3-3-46
Main charger front housing Main charger rear housing
Charger spring
Charger terminal
Tungsten wire
retainer pin
Tungsten wire retainer pin
Not more
than 2 mm
Charger terminal
Charger spring
2-4 mm
Not more
than 2 mm of cut end
Figure 3-3-50 Installing the tungsten wire
6. Wind the new tungsten wire six turns around one end of the charger spring and trim
the end.
• The width of the coiled tungsten wire and the cut end must be less than 2 mm.
7. Hook the other end of the charger spring onto the charger terminal of the main
charger rear housing.
8. Pass the tungsten wire through the V-shaped notch in the tungsten wire retainer pin
and stretch it taut.
• The tungsten wire must be adjusted so that the distance between the spring end
and the rib on the main charger rear housing is 2-4 mm.
9. Insert the tungsten wire retainer pin into the projection on the main charger rear
housing to secure the tungsten wire.
10. Cut off the excess wire under the tungsten wire retainer pin.
• The cut end of the tungsten wire must protrude less than 2 mm.
11. Refit the main charger front and rear lids.
12. Refit all removed parts.