Mita PointSource Ai 3010, Руководство по обслуживанию

Страница: 301 / 478

2AR
3-3-28
6. Wind the scanner wire around the scanner wire drum six turns from the rear toward
the hole in the drum.
7. Insert the locating ball on the scanner wire into the hole in the scanner wire drum.
8. Wind the scanner wire a further two turns from the locating ball toward the machine
front.
6 turns
2 turns
Scanner wire
Rear
Front
Locating ball
Figure 3-3-30 Winding the scanner wire
9. Loop the scanner wire around the groove in the scanner wire pulley at the left of the
scanner unit, winding from below to above. ···························································
4
10. Loop the scanner wire around the front groove in the scanner wire pulley on the
mirror 2 frame, winding from below to above. ························································
5
11. Run the scanner wire around the wire guide at the left of the scanner unit. ···········
6
12. Hook the round terminal onto the scanner wire spring. ··········································
7
13. Hook the other end of the scanner wire spring onto the catch at the machine left.
14. Repeat steps 2 to 13 for the scanner wire at the machine front.
15. Remove the two screws from each of the frame securing tools and then the tools.
16. Move the scanner from side to side to correctly locate the wire in position.