Mita PointSource Ai 3010, Руководство по обслуживанию

Страница: 116 / 478

3-1-23
2AR
6. Refit the upper right cover using four of the six screws.
7. Pass the 4-pin connector of the key counter through the aperture in the key counter
cover retainer, and insert into the 4-pin connector of the machine.
8. Seat the projection of the key counter cover retainer in the aperture in the upper
right cover, and fasten them both to the machine using the remaining two screws.
9. Fit the key counter cover with the key counter assembly inserted to the key counter
cover retainer on the machine using the screw.
4-pin connector
4-pin connector
Key counter cover retainer
(66060021)
Key counter cover
M4
×
10 screw
(B4304100)
M4
×
20 screw
(B4304200)
M4
×
6 screw
(B4104060)
Upper right cover
Jumper
Figure 3-1-26
10. Insert the key counter into the key counter assembly.
11. Turn the main switch on and enter the maintenance mode.
12. Run maintenance item U204 and select “KEY COUNTER.”
13. Exit the maintenance mode.
14. Check that the message requesting the key counter to be inserted is displayed
when the key counter is pulled out.
15. Check that the counter counts up as copies are made.