Toshiba FC22, Руководство пользователя

Страница: 1 / 238

GENERAL PRECAUTIONS REGARDING THE INSTALLATION
AND SERVICE FOR THE COPIER FC-22
The installation and service should be done by a qualified service technician.
1. Transportation/Installation
•
When transporting/installing the copier, move it by the casters while lifting the stoppers.
The copier is quite heavy and weighs approximately 200 kg (441 lb), therefore pay full attention
when handling it.
•
Be sure to use a dedicated outlet with AC 115V or 120V/20A (220V, 230V, 240V/10A) or more for
its power source.
•
The copier must be grounded for safety.
Never ground it to a gas pipe or a water pipe.
•
Select a suitable place for installation.
Avoid excessive heat, high humidity, dust, vibration and direct sunlight.
•
Also provide proper ventilation as the copier emits a slight amount of ozone.
•
To insure adequate working space for the copying operation, keep a minimum clearance of
80 cm (32”) on the left, 80 cm (32”) on the right and 10 cm (4”) in the rear.
2. Service of Machines
•
Basically, be sure to turn the main switch off and unplug the power cord during service.
•
Be sure not to touch high-temperature sections such as the exposure lamp, the fuser unit, the
damp heater and their periphery.
•
Be sure not to touch high-voltage sections such as the chargers, the transfer belt and the high-
voltage transformer.
•
Be sure not to touch rotating/operating sections such as gears, belts, pulleys, fan, etc.
•
When servicing the machines with the main switch turned on, be sure not to touch live sections
and rotating/operating sections. Avoid exposure to laser radiation.
•
Use suitable measuring instruments and tools.
•
Avoid exposure to laser radiation during servicing.
−
Avoid direct exposure to the beam.
−
Do not insert tools, parts, etc. that are reflective into the path of the laser beam.
−
Remove all watches, rings, bracelets, etc. that are reflective.
3. Main Service Parts for Safety
•
The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly impor-
tant for safety. Be sure to handle/install them properly.
4. Cautionary Labels
•
During servicing, be sure to check the rating plate and the cautionary labels such as “Unplug the
power cord during service”, “Hot area”, “Laser warning label” etc. to see if there is any dirt on
their surface and whether they are properly stuck to the copier.