MISUMI DS102MS, Руководство по эксплуатации

Страница: 136 / 166

136
（2） ＣＷＳｏｆｔＬｉｍｉｔＰｏｉｎｔ＿＜Data＞
Command to set CW side Software Limit of each axis.
Setting data is －９９９９９９９９～９９９９９９９９、－９．９９９９９９９～９．９９９９９９９.
*In case of continuing 0 after the decimal point., can be skippable.（Ex.：１．２３０００００＝１．２３）
*In case of data is not a multiple of the travel distance per pulse, corrects it as shown below.
１）Multiple＝Data／Travel distance per pulse
２）Omit the figures after the decimal point of Multiple
３）Data＝Travel distance per pulse×Multiple
（Travel distance per pulse＝Standard resolution of motorized stage÷Dividing number of driver）
（3） ＣＣＷＳｏｆｔＬｉｍｉｔＥｎａｂｌｅ＿＜Data＞
This is setting command of soft limit effective/no effect CCW side for each axis.
＜Data＞ Content
０ Disable CＣＷ Software Limit
１ Enable CＣＷ Software Limit
（4） ＣＣＷＳｏｆｔＬｉｍｉｔＰｏｉｎｔ＿＜Data＞
Command to set CCW side Software Limit of each axis.
Setting data is －９９９９９９９９～９９９９９９９９、－９．９９９９９９９～９．９９９９９９９.
*In case of continuing 0 after the decimal point., can be skippable.（Ex.：１．２３０００００＝１．２３）
*In case of data is not a multiple of the travel distance per pulse, corrects it as shown below.
１）Multiple＝Data／Travel distance per pulse
２）Omit the figures after the decimal point of Multiple
３）Data＝Travel distance per pulse×Multiple
（Travel distance per pulse＝Standard resolution of motorized stage÷Dividing number of driver）
（5） ＤＲｉｖｅｒＤＩＶｉｓｉｏｎ＿＜Data＞
Command to set a dividing number of drivers of each axis.
＜Data＞ <Number of Division/Steps>
０ １／１
１ １／２
２ １／２．５
３ １／４
４ １／５
５ １／８
６ １／１０
７ １／２０
８ １／２５
９ １／４０
１０ １／５０
１１ １／８０
１２ １／１００
１３ １／１２５
１４ １／２００
１５ １／２５０
※ <Data> has only 0, 1 when the normal driver.
※ When a display unit is except a pulse, if the number of driver division is changed, the travel
distance per pulse will change, and there is a case where the following parameters are no
longer a multiple of travel distance per pulse.