MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 40 / 56

Use the origin mark detection
40
Responding to “ERROR 524 WORK ORIGN MARK”
The “ERROR 524 WORK ORIGN MARK” occurs when the Origin mark could not be detected due to an abnormality
occurring during Origin mark detection operations.
Follow the procedures described in the table below to resolve the problem. If no improvement is seen after respond-
ing to the problem, please contact the distributor or one of our sales offices.
Cause Solution
The Origin mark sensor cover remains attached.
Remove the Origin mark sensor cover when using the
Origin mark sensor.
P.38
The Origin mark placed on the work and the sensor
position do not match. Match up the Origin mark with the sensor position again.
P.38
The Origin mark cannot be recognized because the
reflection of the work surface is the same as that of the
Origin mark.
Try using a different tape (black tape if using aluminum
tape, aluminum tape if using black tape).
If it still cannot be detected, use aluminum tape as the
Origin mark after attaching one round of black tape.
There are markings and unevenness on the work surface.
(Markings and unevenness on the work surface may lead
to the misrecognition of the Origin mark).
For markings, use aluminum tape as the Origin mark after
attaching one round of black tape.
For level differences, attach the Origin mark on a
circumference of the surface where there is no
unevenness.
The Origin mark cannot be detected because it is either
too large or too small.
Have the Origin mark be of an appropriate size. P.38
The work does not rotate during Origin mark detection
operations. Check whether there are any points that may be
preventing the work from rotating.
The Origin mark sensor is dirty.
Clean the Origin mark sensor. P.53
If the grime cannot be removed after cleaning and an error
message appears, please contact the distributor or one of
our sales offices.
A strong light hits the Origin mark sensor when detecting
the Origin mark.
Change the direction of the lighting, or close the curtains
on windows letting through daylight so that a strong light
does not hit the sensor.