MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 31 / 56

Set a work
31
Set a work
Set a work
Set the work on the jig.
For Kebab MkII system/Kebab MkII L system, you can set several works of same diameter at the same time.
1
Press the key in the local mode.
2
Press the to select [WORK SET].
3
Press the key.
• The table goes down.
4
Measure the diameter of the work to be drawn
and input it.
• Using a slide gauge, input the correct value.
• Range to input: 10.0 ~ 110.0 mm (
P.54)
5
Press the key.
• Depending on the work diameter, the position to which the work is set in
Kebab MkII system/Kebab MkII L system (small diameter or large diam-
eter) differs. As the position to set the work is displayed on the screen,
set the work by following the display.
• Table for attaching work
• In case of UJF-3042MkIIseries/6042MkIIseries, use the sustaining shaft
of the number shown in the table depending on the diameter of the work.
Diameter of work Less than 45mm More than 45mm
Position to set
work
Small diameter Large diameter
Diameter of work to use Number of sustaining shaft
more than 10 mm and less than 65 mm 1 pc
65mm ~ 110mm 0 pc
M E N U 1 / 3
WO R K S E T >
FUNC1
M E N U 1 / 3
WO R K S E T >
ENTER
WO R K S E T
D I A M E T E R = 4 5 . 7 mm
WO R K S E T
S E T N A R R OW S P A N : e n t
In case that diameter is less than 45.0mm
[UJF-7151 plus series]
WO R K S E T
S E T W I D E S P A N : e n t
In case that diameter is more than 45.0mm
S E T T A B L E S P A C E R 5 0
S E T N A R R OW S P A N
: e n t
In case that diameter is less than 45.0mm
[UJF-30422MkIIseries/6042MkII]
S E T T A B L E S P A C E R 5 0
S E T W I D E S P A N
: e n t
If the diameter is more than 45.0mm and less than 65.0mm
N O T A B L E S P A C E R
S E T W I D E S P A N
: e n t
In case that diameter is more than 65.0mm
ENTER
Example of large
diameter setting
Example of small
diameter setting
Large diameter setting position Small diameter setting position