MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 7 / 56

For safe operation
7
CAUTION
Notes on LED UV
• When handling the glass on the bottom of the
LED UV unit, be sure to wear the gloves attached
and never touch them with bare hands. Or the UV
ink curing level may significantly lower. If the glass
becomes dirty, wipe it with clean gauze moistened
with alcohol. (Do not use alcohol for cleaning the
exterior cover, or the paint will peel off.)
• The LED UV performance and service life are
significantly affected by the UV irradiation and UV
power supply units used. Never use those UV
devices other than those recommended by
Mimaki. We would take no responsibility for any
troubles caused through the use of a UV devices
not recommended by Mimaki.
Cleaning
• After using this machine long time, foreign materials and dust may be gathered on the conductive and insulating
parts, causing electric leakage. Periodically clean such parts.
• For cleaning, do not use compressed air because it scatters foreign materials and dust, which may cause
malfunctions when put inside the conductive parts. Be sure to use vacuum cleaner to vacuum off foreign materials
and dust.
• Do not use the machine in a place where there is a possibility of being wet, or electricity may leak.
• Electrical leakage may lead to electrical shock of personnel or fire.
• To prevent accidents, be sure to carry out periodic inspections and replace periodic replacement parts.
Firing and smoking
• Touching hot parts such as the LED UV with combustible materials may cause firing and/or smoking.
Leaving combustible materials under the LED UV unit for a couple of minutes may also cause firing and/or
smoking.
• After this machine is used long time, foreign materials or dust gathered may cause electrical leakage, or insulation
deterioration may cause firing and/or smoking. Periodically clean this machine and replace the deteriorated parts
after the insulation resistance.
• After this machine is used long time, screws or others on the conductive parts may be loosened, causing firing and/
or smoking. Periodically tighten the screws.
• If abnormalities such as a strange odor, a smoking or a spark burn occurred, turn the power off and call our office
immediately.