MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 41 / 56

Set the start position of drawing
41
Set the start position of drawing
1
Press the key in the local mode.
2
Press the to select [Kebab Origin
Set].
• The [Kebab Origin Set] menu is displayed only when installing the Kebab MkII (MkII L) system.
• Enter the diameter of the work before selecting the menu as the table height differs depending on the diame-
ter.( P.31)
3
Press the key.
• The table moves up and down depending on the diameter of the work, and the table moves forward.
• If a warning message “WORK High” is displayed while the table is moving forward, refer to P.31 “Set a work”
on page 14 and set the work diameter again, and then start from step 1.
• Once the table has finished moving, the mode is set to the Kebab origin
point setting mode.
• When [OriginMarkSearch] is “ON”, start Origin mark detection.
4
Press , and move the red light
pointer “ ● ” mark over the work.
• Move the light pointer mark to where you want to draw, and then set the
origin point position.
• When you press , the slider moves sideways.
• When you press , the work over Kebab rotates.
5
Press the key when the drawing ori-
gin is determined.
• The origin is changed.
• If you press the [END] key without pressing the [ENTER] key, the settings you have made up to
step 4 is canceled, and the work you have set over Kebab rotates and moves back to the position
before the setting menu.
M E N U 1 / 3
WO R K S E T >
MENU
M E N U 1 / 2
K e b a b O r g i n S e t >
ENTER
O R I G I N S E T U P
0 . 0 - - - - -
O R I G I N S E T U P
1 0 . 0 0 . 0
Rotation distance
of the work
Origin position
(right and left)
O R I G I N S E T U P
Y = 3 0 0
ENTER