Wall formwork
Mammut 350
Wall offset
One-sided wall offsets of up to
10 cm are formed by moving
back the standard panel (Fig-
ures 42.1 and 42.4).
For offsets greater than 13 cm
inside corners should be used
(Figures. 42.2 and 42.5).
A wall offset as depicted in
Fig. 42.3 can be created using
inside corners and M outside
corner brackets.
All types of wall offset require
alignment rails for reinforcement.
If the panels are offset as shown
in Fig. 42.3, they can be con-
nected with Uni-assembly locks,
see Fig. 42.5.
Tie rods of any length can be
used to firmly bridge prob-
lem areas, e.g. pilasters, wall
offsets, projecting building
parts. They can be attached
at all multi-function profiles
irrespectively of the tie holes.
Description
Ref. No.
M outside corner bracket .......
23-137-63
Uni-assembly lock 22 .............
29-400-85
Uni-assembly lock 28 .............
29-400-90
Detail A
Wooden blocking
Detail B
Tie rod with articulated flange nut
M outside corner
bracket
Detail A
Detail B
Wooden
blocking
Up to 10
10 to 15
40
25
20
45
Fig. 42.1
Fig. 42.2
Fig. 42.3
Fig. 42.4
Fig. 42.5
Uni-assembly lock
Uni-assembly lock
M350-42
Technical Instruction Manual / Status November 2018
