Metos PROVENO E, Инструкция по установке и эксплуатации, Страница: 66 / 72

66
|
PROVENO E
Rev. 1.2 (24.08.2016) Troubleshooting
MALFUNCTION POSSIBLE CAUSE WHAT TO DO
The kettle does not tilt The lid of the kettle is on and the mixer display
shows a 'Lid' signal Open the lid
The emergency/stop button is pushed Release the emergency-stop switch by turning it
clockwise
The ON/OFF switch is not in the ON position Push the switch to the ON position
The mixer does not start The emergency/stop button is pushed Release the emergency-stop switch by turning it
clockwise
The lid and the safety grid are not in their cor-
rect positions on the kettle, the mixer display
shows a 'Lid' signal Place the lid and safety grid in their correct positions
on the kettle and restart
No mixer mode has been selected after selec-
ting the mixer First select the mixer function and then select the mi-
xing (see the user manual ”Mixing functions”)
The fuses in the main fuse box are blown/
triggered Change/excite the fuses
All above mentioned sections have been
checked, both red error lights on the control
panel are fl ashing The safety switch of the safety grid is damaged and
for safety reasons the operation of the mixer is inhi-
bited. Contact qualifi ed technical personnel.
Other technical fault Contact qualifi ed technical personnel
The mixer stops during
mixing The lid and the safety grid are not in their cor-
rect positions on the kettle, the mixer display
shows a 'Lid' signal Place the lid and safety grid in their correct positions
on the kettle and restart
The emergency/stop button has accidentally
been pushed Release the emergency-stop switch by turning it
clockwise
A pre-set program including stopping of the
mixer is in use Check if a pre-set program is in use
The stuff to be mixed is too thick or there is
too much contents in the kettle Make the contents of the kettle thinner or reduce the
amount and restart
Other technical fault Contact qualifi ed technical personnel
Timing of the kettle not
possible The kettle is not returned to an upright position
after tilting, the temperature display shows a
'PoS' signal Press the tilting reverse button until the kettle is to-
tally horizontal and the temperature display shows an
'On' signal
The lid and the safety grid are not in their cor-
rect positions on the kettle, the mixer display
shows a 'Lid' signal Place the lid and safety grid in their correct positions
on the kettle
Other technical fault Contact qualifi ed technical personnel
The automatic wa-
ter fi lling does not
fi ll any water into
the kettle The shut-off valve of the water sup-
ply line is in the closed position or
the whole water supply network is
closed, an 'Err' message is blinking
on the water fi ll display. Open the shut-off valve or wait until the
water supply is restored, and start the
automatic water fi ll again.
Other technical fault Contact qualifi ed technical personnel
It is not possible
to activate the
EasyRun program The kettle is not returned to an
upright position after tilting, the
temperature display shows a 'PoS'
signal Press the tilting reverse button until the
kettle is totally horizontal and the tempera-
ture display shows a 'On' signal
The lid and the safety grid are not in
their correct positions on the kettle,
the mixer display shows a 'Lid' signal Place the lid and safety grid in their correct
positions on the kettle
Other technical fault Contact qualifi ed technical personnel