Mendota FV46, Инструкция по установке и эксплуатации

Страница: 83 / 96

85-03-01108 FV46 Page 83
How do I change from Celsius to Fahrenheit?
To change between °C to °F, follow these steps:
4. Press the ON/OFF button and turn off the fireplace.
5. Simultaneously, press both the mode button and the thermostat button.
6. Look at the LCD display to verify that your desired indicator ( ° F or ° C) is being displayed.
If not, repeat Step 2.
When do I change batteries in my remote?
When the remote-control batteries are low, a battery icon will appear on the LCD display of
the remote control before all battery power is lost. When the batteries are replaced, this icon
will disappear.
How do I set the child-lock mode?
To prevent unsupervised children from operating the fireplace, a child-lock function is
provided with this remote-control system.
To activate the child-lock function: Simultaneously press the “MODE button” and the “UP
button”.
To deactivate the child-lock function: Simultaneously press the “MODE button” and the “UP
button”.
During the child-lock mode, none of the remote-control buttons will function. You must
deactivate the child-lock function before you can use the remote control.
Thermostat icon disappeared from my remote.
When reinstalling batteries, the thermostat button may have been pressed. To make your thermostat icon reappear, follow
these steps:
1. Remove one battery.
2. Press and hold the thermostat button on the remote.
3. Reinstall the battery while holding the thermostat button down.
4. If you see “set”, the thermostat button is now enabled.
5. If you see “clear”, the thermostat button is disabled.
6. Repeat this procedure if you did not see “set” or “clear” to add/remove the thermostat option.
Why won’t my fireplace turn on?
If your remote control is working, but your fireplace won’t turn on, your fireplace may be in “lockout” mode.
How to reset a lockout:
1. Turn off remote.
2. Turn on remote and wait two seconds.
3. Turn off remote and wait two seconds.
4. Turn on remote and wait two seconds.
5. Turn off remote.
This should clear the lockout mode. Turn on the remote and start the fireplace.
Ensure the master switch is in the run/on position.
After completing these steps, contact your Mendota dealer if fireplace won’t turn on.
What happens when I first light my fireplace?
When you first light your fireplace, the initial curing phase is initiated. During the initial curing phase, a small amount of smoke
and odor will be emitted. This is normal. To complete the curing process, run your fireplace, on high fire, for two hours with the
fans on level 3. Open doors and windows to dissipate any odor. Turn your fireplace off. After it has cooled, run it again, on high
fire, with the blowers off until no smoking or odor remains. Refer to
Chapter 3.1.1 Mendota Fireplace Curing Instructions
for
more information.