Mendota FV46, Инструкция по установке и эксплуатации

Страница: 43 / 96

85-03-01108 FV46 Page 43
3.3 ELECTRICAL TECHNICAL REFERENCES
AC Power Requirements
WARNING: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
For normal operation, this appliance requires 120 VAC, 2 Amp power or a 6V DC power source. The AC power
supply to this Fireplace must be hot at all times and shall not have a switch installed in it.
This appliance is equipped with an electrical junction box on the left side.
Backup DC power supply connector wire harness is supplied with this
fireplace and shall be installed adjacent to this appliance.
Planning for AC Power Connection
On the left-side access box cover, you will find an electrical junction box
with a strain relief clamp. To connect AC power to this Fireplace, follow
these steps:
1. Remove the junction box cover plate (secured with two
screws), route the 3wire end of house power wire cable
through the strain relief in the cover plate.
2. Strip the ends of the house power wires and the three-
color coded wires within the junction box. Connect each
color-coded wire to corresponding colored wires within
the junction box. Use the supplied wire nuts to connect
each wire pair ends.
Note: When connecting two
braided wires using wire nuts,
strip both braided wires ends at
least ½” and twist the two bare
ends together before using wire
nuts. When connecting a braided
wire to a solid copper wire, strip the solid copper wire end ½” and the braided wire end
¾”. Twist the braided wire around the solid copper wire end before applying the wire nut.
3. Place connected wire ends within junction box then close and secure the junction box cover plate.
AC Power Connection
Figure 3-21 Electrical Junction Box
STEP 1
Figure 3-22 Wire Connections
STEP 2 STEP 3
9 7/8"
3"
13 7/8"
4 7/8"
110 VAC
INLET
1/2" FNPT
GAS INLET