Memjet Quadient Rena MACH 6, Руководство пользователя

Страница: 27 / 132

SECTION 2
INSTALLING PRINTER
23
6
6
9. Carefully Close Printhead Latch [6] .
Tip: There will be a little resistance when closing the Printhead Latch with a new system; since the
coupling surfaces are not lubricated (no ink present). Close the Latch slowly to avoid damaging the rubber
O-rings located inside the Ink Revolver Couplings.
10. Check the Touchscreen Display to verify that Printhead Cartridge was recognized.
The Printhead icon should change from a question mark (?) to an outlined
(unprimed, empty) Printhead icon and System Status should change from
“PRINTHEAD_MISSINGQA” to “DOOROPEN_PRINTHEAD”.
Tip : If you don’t see this change, then the system isn’t recognizing the Printhead.
In this case you should tap the “Release Printhead” button, to release the Printhead
Latch. Open Printhead Latch fully. Remove the Printhead and check/clean the contacts.
Use a dry, lint-free cloth. Wet nozzle surface, re-install Printhead and shut Printhead Latch.
If Printhead is still NOT recognized, call for technical support
.
11. Close Printhead Door!
Printer will run a “priming routine” that fills the ink system and Printhead with ink.
During that time “System Status: Maintenance Busy” will be displayed at the top of
the Touchscreen and the following progress bar messages will appear: Printhead
Prime, Ink Circulate, Transfer Wiper.
NOTE: Printer will take about 4 minutes to prime and
prepare the Printhead for use.
IMPORTANT
All Doors must be shut before the Printhead
priming process will begin.
Do NOT open any of the Doors when the
printer is working (priming, performing
maintenance, printing); or the process will
be interrupted.
Tip
: The wiper roller is automatically conditioned during the Printhead Priming process.
12. Watch the Touchscreen Display to identify when Printhead
is finished priming.
The Printhead icon [7] will turn from an outline (Printhead
unprimed ) to a solid orange color (Printhead primed ) and
ONLINE [8] will be displayed in the upper left corner of the
Touchscreen.