Memjet Quadient Rena MACH 6, Руководство пользователя

Страница: 122 / 132

APPENDIX
118
B
C
Removing & Cleaning Wiper Motor Assembly:
1. Using the Touchscreen , select “Menu,” and tap
“Maintenance” from the drop-down menu. Tap
“Inspect Sled” . The Service Station Sled moves
out from under the Printhead Carriage.
2. Open the Printhead Door.
3. Press the Soft Power button to power-down the
printer. Then turn OFF the Main Power Switch.
4. Remove the Wiper Roller, from the Wiper Motor
Assembly. Release the Wiper Roller [
A ] by
pushing the non-geared end toward the Capping
Station
[B] .
This will pop it out of the bracket.
Then lift the Wiper Roller out of the Wiper Motor
Assembly.
5. Gently release the tabs [C] ( one located at each end )
securing the Wiper Motor Assembly to the Service Station
Tray.
6. Carefully disconnect the Wiper Motor’s electrical connection [D].
7. Lift the Wiper Motor Assembly [E] out of the Printer. NOTE: Be careful, watch for dripping ink. Do not
lose the (4) springs that
the Wiper Motor
Assembly rests on.
8. Cleaning: Remove ink
and debris using a soft
bristled brush while
running Wiper Motor
Assembly under tap water. Then rinse the assembly using distilled water and pat dry with a lint free cloth.
CAUTION: Do NOT submerge the motor during cleaning. Try to keep the motor and gear box as dry as
possible while performing this task.
9. Remove protective covering from new Wiper Roller.
10. Install new Wiper Roller.
Make sure gear on Roller engages gear in Wiper Motor Assembly. Carefully snap Roller back into place.
11. If you plan to clean additional Service Station Components continue to next item/section.
If not, reinstall the Wiper Motor Assembly
[E] into the Service Station Tray making sure that the four
springs are present and that the Wiper Motor Assembly locks fully into position.
E
D