Memjet Quadient Rena MACH 6, Руководство пользователя

Страница: 16 / 132

SECTION 2
INSTALLING PRINTER
12
Install Print Platen & Drip Tray Assembly into Printer:
1. Open Ink Tank Door [A] .
2. Release, pull out on, Clamshell Latch [B] ,
to release and raise Clamshell.
3. Insert tabs, at each end of Drip Tray, into frame slots [C] as shown below.
Tip : Larger tab, on Drip Tray, faces towards
operator side of printer.
4. Verify that Print Platen and Drip Tray
Assembly are sitting level in the printer, as
shown below.
Tip : If front or back of Drip Tray is not
sitting level; check to be sure both tabs
are in slots
[C] , shown above.
If front of Drip Tray will not drop into
front slot
[C] ; you may have Drip Tray in
backwards. Remove and rotate 180
degrees so the larger tab is at operator
side of printer. If necessary, bend the tab
on the Grounding Spring
[D] , so it
touches the bottom of the Drip Tray tab.
5. Carefully close the Clamshell and Ink
Tank Door.
CAUTION
It is extremely important that you get Drip Tray tabs into frame slots [C] and that Platen is sitting
level. If not installed properly, media transport issues (skewing, jamming) and or damage to the
system may occur.
A
B