Memjet Quadient Rena MACH 6, Руководство пользователя

Страница: 18 / 132

SECTION 2
INSTALLING PRINTER
14
2. Attach Rear Media Support Guide/Sled Assembly.
A. Remove Knob [3] (thumb screw and washer) and two Flathead Screws [4] from Mounting
Blocks; as shown below.
.
B. Align Nuts, on Mounting Block, before proceeding.
Bottom of Rear Media Support Guide/Sled Assembly has cut-outs
that must fit over Nuts on Mounting Block.
NOTE : Image shown with Guide turned over so you can see
cut-outs for Nuts.
Align Nuts so a flat side is facing the Feed Rollers; as shown.
C. Position Guide so outer holes in Guide fit over the two rear posts (Allen screws); as shown below.
Then loosely install Knob, (thumbscrew and washer).
D. Align holes on top of Guide with holes in the Nuts on Mounting Block; as shown below.
Using the two flathead screws to secure Guide to the Nuts on Mounting Block.
Tip:
If Guide is difficult to reposition (slide), after the two flathead screws are tightened; this is an
indication that the Nuts are not sitting inside the cut-outs on the underside of the Guide. See step
“B” above. Loosen screws and reposition Nuts so they fit into the cut-outs.
E. Tighten Knob (thumb screw) to secure position of Rear Media Support Guide/Sled Assembly.
Tip: It may be helpful to use an
Adjustable Wrench, to hold the Nut
from spinning, when removing these
two screws.
3 4