MaxPac Dual/Triple-Screen 8230 XRA2/3-Series User Operation and Maintenance Guide
89
12)
Figure B-13
Figure B-14
13) Reattach the filter assemble to the main chassis by first slipping the flange of the assemble under
the silver strip at the rear of the chassis (Figure B-14) and then pressing the front edge of the filter
assemble so as to mate the Velcro.
Figure B-15
14) Repeat (or perform at the same time) the above steps for the right-hand filter (Figure B-15).
Resetting the Motherboard BIOS
In the event that your motherboard BIOS is corrupted or lost completely (this could be caused by
failure of the lithium battery, electrostatic discharge, a major power surge, or user error), you may
reset the BIOS as follows:
1) Power the system down completely (a simple
Start > Turn Off Computer > Restart
command is
typically NOT recommended or sufficient) and then initiate the power-up sequence as discussed
in Chapter 1.
2) Due to extensive system initialization and verification checks, the BIOS boot-up process can take
a significant amount of time, especially in the case of systems with large amounts of memory. In
the case of a system containing 8 GB of RAM, for example, it can take 45 seconds before all
three LEDs above the numerical keypad on the keyboard flash. This is your cue to enter the BIOS
setup utility, which you achieve by pressing the <Delete> key on the keyboard. Note that the
system may not immediately respond to your pressing this key, which may be buffered until
Содержание 8230 XRA2 series
Страница 6: ......
Страница 35: ...MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide 29 Figure 2 39 Figure 2 40...
Страница 36: ...30 MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide Figure 2 41 Figure 2 42...
Страница 90: ...84 MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide Figure A 39 Figure A 40...
