MaxPac Dual/Triple-Screen 8230 XRA2/3-Series User Operation and Maintenance Guide
53
3) Observe that the memory sticks are keyed such that they can only be inserted one way. Take the
new (replacement) memory stick sent to you by MaxVision support and gently press it down into
the original slot on the motherboard.
4) Return the system to its initial condition by reversing the order of the operations discussed at the
beginning of this section.
PCI Cards (General)
1) Open the display assembly into its service position as discussed earlier in this chapter.
2) If you are replacing an existing PCI card, use a Phillips #2 screwdriver to remove the 6-32 screw
attaching the card’s retaining bracket to the inner chassis as shown in Figure 3-36. (If you are
adding a new card, remove the corresponding blanking plate screw.)
Figure 3-36
Figure 3-37
3) Gently pull out the old card as shown in Figure 3-37.
4) This particular example features a SATA RAID controller card. In this case, you also need to
disconnect the data cables from the card as shown in Figure 3-38 (see notes below).
Figure 3-38
5) Take the new/replacement PCI card and incorporate it into the system by performing the steps
described above in reverse order.
Note:
It is important to ensure that the data cables are attached to the new card in the same
positions as they occupied on the original card.
Содержание 8230 XRA2 series
Страница 6: ......
Страница 35: ...MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide 29 Figure 2 39 Figure 2 40...
Страница 36: ...30 MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide Figure 2 41 Figure 2 42...
Страница 90: ...84 MaxPac Dual Triple Screen 8230 XRA2 3 Series User Operation and Maintenance Guide Figure A 39 Figure A 40...
