Maxsine EP3 AC Series, Руководство пользователя

Страница: 205 / 246

6.5 Common operation command
195
6.5 Common operation command
The internal parameter of servo drive can be read and written through RS-485
communication interface. After reading and writing were completed, it can do entire operation to
drive parameter list through specific command code.
Firstly, write the operation code to operation command code register. After a certain delay
time, read the operation state register and read out the specific value which means the operation
is completed successfully. The operation address is shown as follows:
Register Operation
Explanation Contact
address Data size
Operate command
code register 0x1100 16bit
Operate state register 0x1101 16bit
The command codes supported by the current edition include “parameter operation is valid”,
“parameter write in EEPROM”, “recover default value”. The detailed explanation of all
command codes is as follows:
Command code
explanation Command
code Completion
state Operation meaning
parameter operation is
valid
0xBB00 0x44FF To make the modified parameters in
parameter list valid
Write parameter in
EEPROM 0x0011 0xFFEE To write the parameters in parameter
list to EEPROM
Recover default value 0x0024 0xFFDB To read the default value of all the
parameter to parameter list